Corporation Microswitch Bracket Kit Installation Instructions

MICROSWITCH BRACKET KIT
For Holley standard-flange carburetors without choke
CATALOG #72282
INSTALLATION INSTRUCTIONS
NOTE: This bracket is not compatible with HP series
carburetors and cannot be used on a carburetor that
requires a choke.
1. Mount switch to bracket so that the arm is pointed away
from the bolt holes and insert screws through switch
and bracket.
2. Thread nuts onto supplied screws, but verify switch arm
alignment before snugging them down.
3. Mount the bracket using the fine threaded holes on the
passenger side of the carburetor that would normally be
reserved for an electric choke housing.
4. Check for full throttle, microswitch operation, and
throttle return.
®
Catalog #72282
Rev. 3/08 - AJ/mc
©2008 Edelbrock Corporation
Brochure #63-72282
IMPORTANT NOTE:
Proper installation is the responsibility of the installer.
Improper installation will void warranty and may result in
poor performance and engine or vehicle damage.
MICROSWITCH BRACKET KIT
For Holley standard-flange carburetors without choke
CATALOG #72282
INSTALLATION INSTRUCTIONS
NOTE: This bracket is not compatible with HP series
carburetors and cannot be used on a carburetor that
requires a choke.
1. Mount switch to bracket so that the arm is pointed away
from the bolt holes and insert screws through switch
and bracket.
2. Thread nuts onto supplied screws, but verify switch arm
alignment before snugging them down.
3. Mount the bracket using the fine threaded holes on the
passenger side of the carburetor that would normally be
reserved for an electric choke housing.
4. Check for full throttle, microswitch operation, and
throttle return.
®
Catalog #72282
Rev. 3/08 - AJ/mc
©2008 Edelbrock Corporation
Brochure #63-72282
IMPORTANT NOTE:
Proper installation is the responsibility of the installer.
Improper installation will void warranty and may result in
poor performance and engine or vehicle damage.