Owners manual

Catalog No. 8126
Rev. 1/19/15 - QT
©2015 Edelbrock LLC
®
EDELBROCK / RUSSELL CHROME STEEL FUEL LINES
For Performer Carburetors
Catalog #s 8126
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mechanic. If you have any questions, please call our Technical Hotline at:
1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday.
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation
will void your warranty and may result in poor performance and engine or vehicle damage.
WARNING! Make sure to perform the installation in a well ventilated area away from any potential fire hazards. Gasoline fumes are toxic and are
highly flammable. Prior to starting the installation, make sure to eliminate all potential fire hazards as fuel leakage can occur when loosening the
fuel system connections. Make sure to check and repair any fuel leaks prior to operating the vehicle.
DESCRIPTION: These attractive chrome steel fuel lines provide a clean and simple method of finishing off your fuel system. Single-feed lines fit
Performer-Series carburetors. These fuel lines feature a 3/8” hose barb and an 1/8” NPT fuel pressure gauge provision.
Single-Feed:
KIT CONTENTS:
q 1 Fuel Line
q 1 Banjo Bolt
q 2 Washer
1. Remove fuel inlet fitting from carburetor.
2. Attach new fuel line to carburetor using washers and banjo bolt as shown (See Figure 1). Do not fully tighten.
3. Adjust the fuel line for straightness if necessary (See Figure 2 for reference).
5. Tighten all connections and attach appropriate fuel line from fuel pump or fuel pressure regulator to the 3/8” barbed end inlet.
6. Plug the 1/8” NPT provision if not being used.
7. Start engine or turn on electric fuel pump (if independently switched). Check for leaks.
CAUTION: If leaks exist, immediately shut off engine (or electric fuel pump) and fix leaks before continuing!
INSTALLATION PROCEDURE
Banjo Bolt
Washer
Fuel Line
Washer
Figure 1
Figure 2
Edelbrock LLC • 2700 California St. • Torrance, CA 90503
Tech Line: 800-416-8628