User guide

OPERATING INSTRUCTIONS
32
USER GUIDE
TABLE OF CONTENTS INTRODUCTION PARTS DESCRIPTION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
TABLE OF CONTENTS INTRODUCTION PARTS DESCRIPTION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
SET POINT
This value is used to trigger the
alert
SOUND DURATION
You can adjust the duration of
the alert sound by using this
menu option. Simply press the
up/down arrow until you have
the desired sound length in
seconds.
SCREEN LAYOUT
The screen Layout menu (Fig-
ure 19) allows you to choose
from fi ve different screen layout
options. The Analog Gauge
Screen is set as the default.
Once you’ve selected the gauge
screen you want to use, you can
customize which parameters
are displayed on each available
gauge by:
1. CTS - Touching the param-
eter value on the main screen.
2. CS - Press enter button while
on the main screen.
Once these are pressed, you can
pick the desired PID from the
list provided.
Figure 19
BACKLIGHT AUTODIM
The CS and CTS devices both
have ambient light sensors. As
it get’s darker outside, the de-
vice will automatically dim the
screen for easier viewing. The
Auto Dim feature allows you
to set how far it will dim the
screen.
NOTE: It’s best to make this
adjustment at night so you can
verify the screen brightness is
correct. You’ll need to return
to the main display screen after
setting
the Autodim percent in
order to see the changes.
The default is set at 99%. This
max setting provides the largest
range between the brightest the
screen gets during the daylight,
and the darkest the screen will
get at night. A 1% setting will
provide the same brightness
during the day as the 99% set-
ting, but will remain bright with
little to no change at night.
MENU TIMEOUT
The CS and CTS devices have
a built in time-out feature. The
purpose of this time-out is to
prevent the unit from staying
powered up for excess amounts
of time. If you leave the device
in a menu option and then exit
the vehicle, the device will stay