User guide

OPERATING INSTRUCTIONS
34
USER GUIDE
TABLE OF CONTENTS INTRODUCTION PARTS DESCRIPTION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
TABLE OF CONTENTS INTRODUCTION PARTS DESCRIPTION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
will be programmed into the
PCM and re-calibrate the
speedometer.
ACCESSORY OPTIONS
Accessory options allow you to
adjust add on features such as
the Edge Expandable Accesso-
ries System( EAS). As other ac-
cessories are added, additional
options will also be added.
NOTE: If you don’t have a
camera or other RCA device
connected to the CTS device,
the camera menu options will
be available but non func-
tional.
Figure 21
CAMERA DELAY - CTS ONLY
The CTS is designed to auto-
matically engage the back-up
camera when the vehicle gear
selector is in Reverse (the CTS
must be able to detect gear
position for this to function
properly). The camera delay
will allow you to customize
the delay time for the device to
switch from the main viewing
screen to camera view. If this
is set too short then you’ll see
the device blink as you move
the gear selector past Reverse.
If it’s set too long the screen
may not appear before you start
backing up. Some vehicles
will communicate gear position
faster than others, so this menu
option allows you to customize
the delay.
CAMERA AT STARTUP
Turning this feature ON allows
you to automatically see your
camera during startup. Touch
the screen to return to the main
gauge screen.
TURBO COOL DOWN SETUP
Figure 22
This menu allows the engine to
continue running (after key-off)
until one of three conditions are
met. 1) If the EGT falls below
the target set point or 2) The
time set expires. 3.)Pressing ei-
ther the brake pedal, gas pedal,
button, or touch screen. Your
display will tell you which one
pertains to your vehicle.