User guide

APPENDIX
52
USER GUIDE
TABLE OF CONTENTS INTRODUCTION PARTS DESCRIPTION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
TABLE OF CONTENTS INTRODUCTION PARTS DESCRIPTION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
sensor, Edge recommends you
purchase an Edge Products sen-
sor and install it in a pre-turbo
location.
As noted in the accessories
section, you can purchase an
Edge Products EGT sensor to
be coupled with the Edge Ac-
cessories System ( EAS) or you
can purchase a standalone Edge
EGT sensor. Either of these
items can be purchased at www.
edgeproducts.com or at your
local Edge Products Authorized
MVP Dealer.
If you are unsure whether or not
your vehicle is equipped with a
pre-turbo EGT sensor please see
the diagram on the following
page.
If you are unsure what tem-
perature range is acceptable on
your EGT’s we recommend you
do the following:
1 - Display EGTs on your main
display screen
2- Observe what EGTs are dis-
played while at a stock power
level and accelerating at a heavy
load, i.e. pulling a heavy trailer
up a long hill.
3 - 1350 F is the highest recom-
mended exhaust gas tempera-
ture.
The following Illustrations rep-
resent the 2007.5 + light-duty
diesel pickups.
(NOTE: Additional EGT instal-
lation instructions can be found
in the Juice Supplement Instal-
lation Instructions manual as
well as the EAS Installation
Instruction manual.)
The Dodge 6.7 Cummins is not
equipped with a pre-turbo EGT
sensor. It is however equipped
with three EGT sensors down-
stream from the turbo. All of
these sensor’s readings are
available for display on the CS
and CTS. However they are not
an accurate representation of
combustion chamber tempera-
tures. (Figure 39)
The GM LMM Duramax is not
equipped with a pre-turbo EGT
sensor. It is however equipped
with two EGT sensors down-
stream from the turbo. Both
of these sensor’s readings are
available for display on the CS
and CTS. However they are not
an accurate representation of
combustion chamber tempera-
tures. (Figure 39)
The Ford 6.4 Powerstroke has
an EGT sensor placed in the
passenger side up pipe prior to
the turbo. This is an excellent
location for an EGT sensor.
The readings you’ll see here
represent the temperatures in
the combustion chamber than
the temperatures you would see
down stream. (Figure 39)