Operation Manual

3
Congratulations on your selection of
the Chef’sChoice
®
Commercial
Knife Sharpener Model 2100!
You will find the Chef’sChoice
®
Model 2100 Sharpener puts an exceptionally sharp and
durable edge on all of your knives. It is backed by EdgeCraft, the World Leader in Cutting
Edge Technology
®
.
The Model 2100 incorporates advanced EdgeCraft diamond abrasive, honing and stropping
technology to produce the sharpest and most durable edges of any sharpener available
today. With it you can quickly and reliably develop a shaving-sharp edge on all your knives.
Once your knives have been sharpened on the Model 2100, resharpening takes less than
1 minute. Consequently if the Model 2100 is conveniently located in your work area, you
can resharpen so rapidly that your knives can be maintained razor sharp every day.
UNPACKING AND PREPARING FOR OPERATION
The Model 2100 has a cast metal motor-drive housing and a detachable Sharpening
Module that are packed together but are not assembled (See Figure 1).
To assemble the Model 2100, insert the Sharpening Module into the guide rails of the
motor-drive housing, (Figure 2) and slide the module toward the motor compartment until
it locks in place. If the sharpening module does not snap together easily and quickly, follow
the instructions in the “Inserting Sharpening Module” section, (Page 12) of this manual.
Figure 1. Model 2100 sharpener disassembled.
On/Off Switch
Release ButtonMotor-drive Section
Detachable Sharpening Module