Use and Care Guide

12
Using the Control Panel
LED Display
In cooling mode and auto-timer setting the display will show the set temperature in either ºC or
ºF (To switch between ºC or ºF, press and hold the - and + buttons at the same time for three
(3) seconds.) In dehumidify or fan mode the display will show the current temperature of the
room. The LED display will also display error codes and alerts. Refer to the Error Code section
in this manual for additional information.
Mode
Select the desired mode setting. Each time you press the “mode” button a mode is selected in a
sequence: AUTO – COOL – DRY – FAN. The mode indicator light will illuminate to show the
selected setting.
Auto
Press the MODE button until the AUTO indicator light comes on. When the air conditioner is set
in AUTO mode it will automatically select cooling or fan depending on what temp er atu re you
have selected and the current ambient temperature. In this mode, you cannot select the fan
speed.
Cool
Press the MODE button until the COOL indicator light comes on. Press the - and + arrows to
select your desired room temperature. Press the FAN button to choose the fan speed.
Dry (Dehumidify)
Press the MODE button until the DRY
indicator light comes on. In this mode, you cannot select
a fan speed or adjust the temperature.
Fan
Press the MODE button until the FAN indicator light
comes on. Press the FAN button to
choose the fan speed. The temperature cannot be adjusted.
Power Button
Use the Power button to turn the portable air conditioner on and off. By default, when you first
use the power button, the unit will begin to operate in cooling mode. The unit will remember the
last used mode/settings if you shut down and restart.
Auto-Restart: If power to the unit is interrupted, the air conditioner will restart itself in its last
used mode/settings once power is restored. The compressor will restart after 3 minutes.