Manualshelf

Use and Care Guide

ManualsBrandsEdgeStar ManualsPortable Air ConditionersLarge Room Quickly Cools Up to 500 Square -ft 115V Portable Air Conditioner with Dehumidifier, Window Mounting Kit and Remote Control White
11121314151617181920
13
Swing
When the Power is ON, the louvers open fully.
Press the SWING button on the panel or remote control to initiate the Auto swing feature. The
louver will swing up and down automatically.
Note: Do not adjust the louver manually.
Timer
When the unit is on, press the timer button to initiate the Auto-off stop program. The TIMER
OFF indicator light will illuminate. Press the + or - button to select the desired time. Press the
TIMER button again within five seconds; the Auto-on start program is initiated and the TIMER
ON indicator light will illuminate. Press the + or - button to select the desired Auto-on start time.
When the unit is off, press the TIMER button to initiate the Auto-on start program. Press it again
within five seconds and the Auto-off stop program will initiate.
Press or hold the + or - button to change the Auto time by 0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours. The control will count down the time remaining until
the unit starts. The system will automatically revert back to display the previous temperature
setting if there is no operation in a five second period.
Sleep
Select to initiate the SLEEP operation. When you press this button, the set temperature will
increase by 1ºC / 2ºF in 30 minutes. The set temperature will then increase by another 1ºC / 2ºF
after an additional 30 minutes. This new temperature will be maintained for 7 hours before it
returns to the originally selected temperature. This ends the SLEEP mode and the unit will
continue to operate as originally programmed.
Note: This feature is only available in COOL and AUTO mode.
Decrease (-) / Increase (+)
These buttons are used to adjust the temperature settings in the range of 62ºF (17ºC) to 88ºF
(30ºC) or the TIMER setting in the range of 1-24 hrs.
The control panel is capable of displaying temperature in Fahrenheit or Celsius. To convert
from one to the other, press and hold the - and + buttons at the same time for 3 seconds.
Fan
Press to select the fan speed setting - LOW, MED, HIGH or AUTO. The fan speed indicator light
will illuminate to show the selected setting.