Use and Care Guide

16
Button
Function
On / Off
Press the ON / OFF button to start or stop the unit after the desired settings have
been selected.
Mode
Press the MODE button until you reach your desired operation mode. The
remote cycles through the following modes: Auto, Cool, Dry, Heat*, and Fan.
*The remote includes a heat mode symbol even though the air conditioner itself
does not have a heat function. You will still be able to use the remote to control
functions such as auto swing, power on/off, and LED on/off while in heat mode,
but you will need to cycle into a different mode in order to adjust air flow and
temperature settings.
Fan
Press the MODE button and select FAN mode. Then press the FAN button to
select the fan speed: AUTO, LOW, MED, or HIGH.
Sleep
The SLEEP function is used to decrease energy use while you sleep and don’t
need the same temperature settings as when you are awake. This function is not
available in FAN or DRY mode.
Swing
This button is used to stop or start louver movement and set the desired up /
down air flow direction. The louver changes 6 degrees in angle for each button
press. If the swing button is held down for more than two (2) seconds, the louver
auto swing feature is activated.
Follow Me
Enables the remote control to measure the temperature at its current location.
When in AUTO or COOL mode the remote measures the temperature (instead of
the unit) and optimizes the temperature around you to ensure maximum comfort.
Press button to turn on Follow Me feature. Press again to turn it off. This feature
can ONLY be activated from the remote control.
LED
Display
See the above diagram for LED display details. The display shows the set
temperature in °C or °F and the timer settings. While on DRY and FAN modes,
the LED display will show the room temperature. The display shows Error codes
and Protection codes as well (see Error Codes section.)
Short Cut
This button is used to restore the current settings or resume the previous settings.
When this button is pressed, the unit will automatically revert back to the previous
settings including operating mode, setting temperature, fan speed level, and
sleep feature (if activated). If the Short Cut button is pressed for more than two
(2) seconds, the unit will revert to the current settings.
Timer On
Press the TIMER ON button to set the time period for when the unit will
automatically turn on. For example, if you set TIMER ON for two hours, the unit
will turn on after two hours. Continue to press the TIMER ON button until the
desired time setting is reached.
Timer Off
Pres the TIMER OFF button to set the time period for when the unit will
automatically turn off. For example, if you set TIMER OFF for 2 hours, the unit will
turn off after 2 hours. Continue to press the TIMER OFF button until the desired
time setting is reached.
LED
This button turns the unit’s LED display on or off.
Up / Down
Use the Up and Down arrows to increase or decrease the settings that you are
adjusting.