Use and Care Guide

19
Maintenance
Clean the air conditioner and filters regularly to maximize performance and efficiency, and
prolong the unit’s life. Be sure to always unplug the air conditioner from the power outlet before
cleaning.
Cleaning the Unit
Use a soft dry cloth to wipe the body clean. If necessary, use lukewarm water to dampen a cloth to
clean the unit. Use a soft bristle brush to clean between the vents. Carefully use a vacuum cleaner
to clean the condenser coils.
Never use abrasive chemicals, volatile substances, gasoline, detergents, chemically treated cloths,
or other cleaning solvents that may damage the cabinet exterior. Never spray water directly on the
unit.
Cleaning the Pre-filter
To clean the pre-filter, follow the steps below:
1. Power off the unit and remove the pre-filter.
2. Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt, then rinse
thoroughly under lukewarm running water (below 104°F). You may use a mild soap and water
solution if needed. Allow the pre-filter to air dry in a cool and shaded place. Dry thoroughly
before reinstalling.
Clean the pre-filter periodically. If the unit is used in a dusty environment you may need to clean it
on a weekly basis.
Preparation for Storage
If you are not going to be using the unit for an extended period of time, follow the instructions
below before storing your unit:
1. Drain all the water from the unit’s reservoir. Operate the unit in fan mode for a few hours to
thoroughly dry any moisture left on the coils inside the unit.
2. Power off the unit, and clean or change the filters.
3. Unplug and carefully wind the power cord.
4. Remove the exhaust hose and adapters and keep them in a safe place.
Warning: Never operate the unit without the pre-filter.