Use and Care Guide

Installation in a Double Hung Sash Window

Step 1: Cut the foam seal to the proper length and attach it to the window sill, and window frame

as shown in the image to the left. Your window kit includes four (4) adhesive backed foam strips for

this step, two that are short and two that are longer.

Step 2: Attach the window slider kit to the window sill. Adjust the length of the window slider kit

according to the width of the window. Use the winder slider “bolt” to secure the slider to the correct

width. Open the window sash and place the window slider kit on the window sill then close the

window sash securely against window slider kit.

Step 3: Cut the foam seal to an appropriate length and seal the open gap between the top window

sash and outer window sash.

Note: If desired, you may choose to attach the adhesive foam seal to the window slider kit instead

of the window sill and frame.

Note: If needed, you may trim the adjustable window kit if the width of the window is less than

”