Owner's Manual
Table Of Contents
11
Installing the Door Handle
To install the door handle:
1. Open the door and carefully pull the door gasket around the area where the handle is to
be installed.
2. Carefully remove the two pre-installed decorative plugs from the front of the door.
Insert each Phillips head screw through the gasket side of the door until the screw
passes through the door.
4. Align the handle with the screws and tighten using a Phillips head screwdriver until the
5. Carefully press the door gasket into its original position.
Note: Some refrigerators do not have decorative plugs installed.
Warning: Do not over-tighten the screws as this may cause damage to the handle or the
stainless steel door.
!
Installing the Shelves
To prevent damaging the door gasket, make sure to open the door fully before pulling the
1. Open the door completely.
2. Slide the shelf on the shelf track and slowly push back until it stops.
Install the plastic notches.
Removing the Shelves
1. Open the door completely.
2. If necessary, make sure you remove all the contents sitting on the shelf.
Remove both of the plastic notches with a screwdriver.
4. Pull the shelf forward until it is completely removed from the inner compartment.