Owner's Manual

Installing the Door Handle

To install the door handle:

1. Open the door and carefully pull the door gasket around the area where the handle is to

be installed.

2. Carefully remove the two pre-installed decorative plugs from the front of the door.

3. Insert each Phillips head screw through the gasket side of the door until the screw passes

through the door.

4. Align the handle with the screws and tighten using a Phillips head screwdriver until the

handle is flush against the door frame.

5. Carefully press the door gasket into its original position.

Installing and Removing the Shelves

To prevent damaging a door gasket, make sure to open the door all the way before pulling the

shelves out of their track.

To Install the Shelves:

1. Open the door completely.

2. Slide the shelf on the shelf track and slowly push back until it stops.

3. Install the plastic notches.

To Remove the Shelves

1. Open the door completely.

2. If necessary, make sure you remove all the contents sitting on the shelf.

3. Remove both of the plastic notches with a screwdriver.

4. Continue to pull the shelf forward until it is completely removed from the inner

compartment.

Note: some wine coolers do not have decorative plugs installed.

Caution: Do not over-tighten the screws as this may cause damage to the handle or to the

stainless steel door.