Owner`s manual

EdgeStar Washer/Dryer Combo 8
Installation
Connect inlet pipe
Connect the inlet pipe as indicated in the figure below.
Connect the hot inlet valve to the hot water tap and cold inlet valve to
the cold water tap.
Install inlet pipe
Connect the elbow to the inlet valve at the backside of washing machine
and fasten it turning clockwise. Connect the other end of inlet pipe to the
tap and fasten the pipe tightly clockwise.
Note: After connection, if there is any leakage from hose, then repeat the steps to
connect inlet pipe. The most common type of tap should be used to supply water.
If tap is square or too big, a new tap is required.