Owner Manual

Installing the Door Handle

To install the door handle:

1. Open the door and carefully pull the door gasket around the area where the handle is to

be installed.

2. Carefully remove the two pre-installed decorative plugs from the front of the door.

3. Insert each Phillips head screw through the gasket side of the door until the screw passes

through the door.

4. Align the handle with the screws and tighten using a Phillips head screwdriver until the

handle is flush against the door frame.

5. Carefully press the door gasket into its original position.

Installing and Removing the Shelves

To prevent damaging a door gasket, make sure to open the door all the way before pulling the

shelves out of their track.

To Install the Shelves:

1. Open the door completely.

2. Note the location of the protective stoppers on the right and left side of the back of

each shelf.

3. Lift either side of the shelf to create a 45° angle.

4. Insert the shelf at the desired shelf slot and push back slowly until it stops in place.

5. Gently lower the shelf down into place.

To Remove the Shelves

1. Open the door completely.

2. Make sure the shelf is pushed in completely towards the back of the Wine Refrigerator.

3. If necessary, make sure you remove all the contents sitting on the shelf.

4. Lift either side of the shelf to create a 45° angle and raise the shelf slightly to avoid

the shelf mounts on the inside of the cabinet.

5. Pull the shelf straight out until it is completely removed. Set aside gently.

Note: some wine refrigerators do not have decorative plugs installed.

Caution: Do not over-tighten the screws as this may cause damage to the handle or to the

stainless steel door.