Owners Manual

8
Installation
The wine refrigerator should be installed in accordance with local electrical code requirements. The
wine refrigerator should also be placed in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully loaded than when empty. Before you
plug the wine refrigerator into a power supply, be sure to let it stand upright for at least 24 hours
to allow the compressor’s oils to settle.
Unpacking the Wine Refrigerator
Warning: Use two or more people to move and install the wine refrigerator. Failure to do
so can result in back or other injury. Carefully remove the packaging materials. Remove
any shipping tape and glue from your wine refrigerator before use. Do not use sharp
instruments, rubbing alcohol, ammable uids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your wine refrigerator.
!
Warning: Do not remove any safety, warning, or product information labels from your wine
refrigerator.
!
Warning: DO NOT install the wine refrigerator behind a closed cabinet door.
This wine refrigerator has been designed for freestanding installation only, There must be adequate
ventilation and access for service.
Freestanding Installation:
A freestanding installation will allow you to install the wine refrigerator in almost any place you desire.
You must follow the stated instructions for electrical requirements and leveling the wine refrigerator.
Built-in Installation:
A built-in installation will allow you to install the refrigerator under a counter as long as the required
clearance space around the refrigerator is provided. It is necessary to allow adequate ventilation space
around the unit, including at the back of the unit.
The following additional items must be observed:
1. Place the refrigerator in front of the installation location. Adjust the feet and place the unit at on the
oor or on a platform depending on your installation requirements.
2. If the electrical outlet for the refrigerator is behind the cabinet, plug in the refrigerator.
3. Push the refrigerator into position.
Types of Installation
!