Owners Manual

9
Note: The wine refrigerator should be installed on a rm and level surface that will be able
to support the entire weight of a fully loaded unit. It is important for the wine refrigerator
to be level in order to work properly. If needed, you can adjust the height of the wine
refrigerator by rotating the feet. See the “Leveling the wine refrigerator” section.
Note: A standard electrical supply (115V AC only, 60 Hz), properly grounded in accordance
with National Electrical Code and local codes and ordinances, is required.
Notes:
• Choose a location that has ambient temperatures above 50° F and below 90° F. Operation
outside these temperatures may result in lowered e󰀩ciency or cause other adverse e󰀨ects.
• This unit MUST be installed in an area protected from the elements, e.g. wind, rain, water
spray or drips.
• The wine refrigerator should not be located next to ovens, grills, or other heat sources.
• Do not kink or pinch the power supply cord between the wine refrigerator and the wall or
cabinet.
Clearance Requirements
When installing the refrigerator under a counter, follow the recommended spacing dimensions shown.
To ensure proper service access and ventilation, allow at least 1-2” of clearance at the back, 1/4” at
the top, and 1/4” at the sides. If the door side is against a wall, allow at least 2-3/8” of clearance. The
installation should allow the unit to be pulled forward for servicing, if necessary.
Wall
2-3/8” Min.
1-7/8 ”
Wall
2-3/8” Min.
1 - 2”
1/4”
1/4”
12-1/4”
1/4”
1 - 2”
Top View: Side View: