Owner's Manual

7
Warning: Use two or more people to move and install the Wine Cooler. Failure to do so can
result in back or other injury. Carefully remove the packaging materials. Remove any shipping
tape and glue from your Wine Cooler before use. Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can
damage the surface of your Wine Cooler.
Important: Do not remove any safety, warning, or product information labels from your Wine
Cooler.
Installing the Wine Cooler
The Wine Cooler should be installed in accordance with local electrical code requirements.
The Wine Cooler should also be placed in a location that is strong enough to support its total
weight, keeping in mind that it will weigh substantially more when fully loaded than when empty.
Before you plug the Wine Cooler into a power supply, be sure to let it stand upright for
at least 24 hours to allow the compressor’s oils to settle.
Unpacking the Wine Cooler
Types of Installation
This Wine Cooler has been designed for free-standing or built-in installation. In each case,
there must be adequate ventilation and access for service.
Free-standing Installation:
A free-standing installation will allow you to install the Wine Cooler in almost any place you
desire. You must follow the stated instructions for electrical requirements and leveling the
Wine Cooler.
Built-in Installation:
A recessed installation will allow you to install the wine cooler under a counter or in a
kitchen cabinet as long as the required clearance space around the wine cooler is
provided. It is necessary to allow adequate ventilation space around the unit, including at
the back of the unit. The following additional items must be observed:
1. Place the Wine Cooler in front of the installation location. Adjust the feet and place the
unit flat on the floor or on a platform depending on your installation requirements.
2. If the electrical outlet for the Wine Cooler is behind the cabinet, plug in the Wine
Cooler.
3. Push the Wine Cooler into position.
Tip: Gather the model
and serial number
from the product label
and write them down
before installing the
Wine Cooler.
Warning: DO NOT install the Wine Cooler behind a closed cabinet door.