Owners Manual

22
2. Use a bristled brush and run it through the orifices of the burner several times.
3. Go over the exterior of the burner with a wire brush several times to loosen debris and
residue. You may also wipe it with a terry cloth or damp rag without using any chemicals.
For stubborn scale, you may use a scraper.
4. Look at all burner ports (the small openings) and run a pipe cleaner or thin wire through
them.
5. Analyze the burner for corrosion and any damage caused by corrosion.
Reinstalling the Burner(s)
1. Ensure that the gas is shut off prior to attempting to reinstall each burner.
2. Carefully reinstall the burner back into the firebox.
3. Check that the burner is firmly in place in its proper location after replacing. Make sure the
tubes on the bottom of the burner are inside the venturi tube opening (see below). These
tubes MUST be seated inside the venturi tube opening; if not, gas will escape and there is
a risk for fire or explosion.
4. Reconnect the ignition wires.