Installation Sheet
7
Important:
• Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of ice cubes must be discarded.
• Never turn the water supply tap off when the ice maker is working.
• Never touch the evaporator when the machine is running.
• Except to take ice from the unit, keep the door closed to reduce melting and ensure proper ice
formation.
Operation
Final Check List before Operation
1. Have all packing materials and tape been removed from the interior and exterior of the ice
maker?
2. Did you clean the ice storage bin and water trough?
3. Have the installation instructions been followed, including connecting the machine to water and
electricity? Does the unit have proper drainage?
4. Has the machine been leveled?
5. Is the ice maker in a site where the ambient temperature is between 55º F and 90º F and the
water temperature is between 41º F and 77º F all year round?
6. Has the water supply pressure been checked to ensure a minimum of 15 psi with a static pressure
not to exceed 80 psi?
7. Is there a clearance of at least 4” at the rear,
1
/
2
” at the top and
1
/
2
” at the sides for proper air
circulation?
8. Has the power supply voltage been checked or tested against the nameplate rating? And has
proper grounding been installed for the ice maker?
9. Is the ice maker plugged in?
10. Have you turned on the main water supply and the tap?
11. Have you checked for leaks at all water supply connections and at the drain?
Operating Method
1. Turn on the water tap, then turn the power switch on the front panel to the ON position. The water
trough will fill and after approximately 4 minutes the ice maker will start working automatically.
2. After the first feeding of water, the machine will automatically go to the ice making stage, and the
sound of spraying water will be heard.
3. Ice will be harvested to the ice storage bin. When the storage bin is filled to the point that the ice-
full sensor is covered, the ice maker will automatically stop working. The machine will restart
making ice once the storage bin is less than full.
4. Excess water will flow through the drain outlet at the back of the machine and empty into the
floor drain.