Use and Care Guide
6
1. Select the size of the ice cube by pressing the “Select” button. If the room temperature is
lower than 60℉, it is recommended to select the small or medium ice sign button in order to
avoid ice sticking together.
2. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the level mark.
3. Press “Power” button on the control panel to begin the ice making cycle.
4. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cube selection
and the ambient temperature. In extreme hot room temperatures, ice making time may
vary.
5. While the icemaker is on, verify water level periodically. If water pump can’t inject water, the
ice maker will stop automatically, and the “Add Water” indicator will be on.
Press “Power” button, fill water up to the level mark and press “Power” button again to turn
on the unit again.
Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting.
6. The ice maker automatically stops working when the ice basket is full and the “Ice” indicator
will be on.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit isn’t in use, drain all water left in the tank.
USING YOUR ICE MAKER
PROBLEM POSSIBLE CAUSE SOLUTION
“
Add W
ater” indicator is
on.
Lack of Water.
Stop the ice
maker, fill water, and
press “Power” button again to
restart the unit.
“Ice” indicator is on.
There is too much ice. Remove ice from ice basket.
Ice cubes stick together.
The ice cycle is too long.
Stop the ice
maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
Water temperature in inner
tank is too low.
Change the water in the inner
t
ank. Temperature of water is
better set between 45℉-90℉.
Ice making cycle is normal
but no ice is made.
Ambient temperature or
water temperature in inner
tank is too high.
Please run the ice
maker below
90℉ and pour colder
water into
tank.
Refrigerant liquid leakage.
Verify by a qualified technician.
Pipe in the cooling system
is blocked.
Verify by a qualified technician.
TROUBLESHOOTING