Use and Care Manual

7
ELECTRIC SHOCK HAZARD!
 Plug into a grounded 3-prong outlet.
 Never remove the grounding prong from the plug.
 Never use an adapter to bypass the grounding prong.
 DO NOT use an extension cord.
 Failure to follow these instructions can result in fire, electrical shock, or death.
Warning: Use two or more people to move and install the kegerator. Failure to do so can result
in back or other injury.
Important: Do not remove any safety, warning, or product information labels from your
kegerator.
kegerator should also be placed in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully loaded than when empty.
Before you plug the kegerator into a power supply, be sure to let it stand upright for at least 24
hours to allow the compressor’s oils to settle.
Unpacking the Kegerator
Carefully remove the packaging materials. Remove any shipping tape and glue from your
kegerator before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage the surface of your
kegerator.
Electrical Requirements
Before you move your kegerator into its final location, it is important to make sure you have the
proper electrical connection:
A standard electrical supply (115 V, 60Hz), properly grounded in accordance with the National
Electrical Code and local codes and ordinances, is required.
It is recommended that a separate circuit, serving only your kegerator, be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
The fuse (or circuit breaker) size should be 10 Amps or greater.