Use and Care Manual

8
Important: Once you are ready to install it in a cabinet or directly on the floor, you must adjust
the feet to level the kegerator.
Recommended Grounding Method
For your personal safety, this appliance must be grounded. It is equipped with a power
supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord
must be plugged into a mating 3-pronged wall socket, and grounded in accordance with the
National Electrical Code and local codes and ordinances. If a mating wall socket is not
available, it is the personal responsibility of the customer to have a properly grounded, 3-
prong wall receptacle installed by a qualified electrician.
Leveling the Kegerator
It is important for the kegerator to be leveled in order to work properly. It can be raised or
lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine. If
you find that the surface is not level, rotate the feet until the kegerator becomes level .You may
need to make several adjustments to level it. We recommend using a carpenter’s level to check
the machine.
1. Place a carpenter’s level on top of the product to see if the kegerator is level from front to
back and side to side.
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower that side of the kegerator.
Turn the leveling feet to the left to raise that side of the kegerator.
Installing the Stainless Steel Door Handle
BR7001SS, BR7001SSOD models only
To install a door handle:
1. Remove the four screws from the side of the door. This
should be the side opposite of the door hinge.
2. Place and align the openings of the handle hinges over the
screw holes in the side of the door.
3. Insert and tighten the screws to hold the handle in place.