Use and Care Guide

Note: Discard the rst three batches of ice produced by the ice maker.

Note: If the water pump is unable to detect or pump water, the unit will stop automatically,

and the “Add Water” indicator will illuminate. Once you have added water to the unit, it will

restart automatically and continue making ice as normal. Do not power on the unit without

any water.

Note: Direct sunlight may cause the “ice full” infrared sensor to malfunction. If the unit

continues to produce ice even though the basket is full, you may need to move the unit away

from the sunlight.

Operation

Installation Checklist before Operation

First Time Operation

1. Have all packing materials and tape been removed from the interior and exterior of the ice maker?

2. Have the installation instructions been followed, including connecting the machine to electricity?

And has proper grounding been installed for the ice maker?

3. Is the ice maker in a site where the ambient temperature is between 50° F and 90° F all year

round?

4. Has the unit been thoroughly cleaned prior to use?

5. Is there a clearance of at least 4” around the back and sides of the unit?

1. Pour water into the water reservoir. Keep the water level below the “MAX” water mark.

2. Insert the ice basket into the water reservoir.

3. Close the lid.

4. Plug the ice maker’s power plug in to a grounded outlet.

5. Press the On/O󰀨 button on the Control Panel.

6. Press the Select button to choose between small, medium and large size cubes. If the room

temperature is below 60°F, it is best to select the small size setting; otherwise, the ice cubes may

stick together.

7. The ice making cycle should produce one batch of ice in approximately 13 muntues.