USB Audio Interface/ MIDI Keybroad Controller PC-80 Owner's Manual
Table Of Contents
- USING THE UNIT SAFELY
- Important Notes
- Contents
- Contents of the package
- Names of things and what they do
- Setup
- Operation
- Appendix
- Using the PC-80 as a MIDI controller keyboard
- Basic connection example and signal flow
- The PC-80’s basic operating modes
- Transmitting various MIDI messages from the PC-80
- Setting the MIDI transmit channel
- Selecting sounds—Transmitting Program Change and Bank Select Massages
- Starting/stopping playback data—Transmitting a Start/Stop/Continue message
- Transmitting messages to an external MIDI sound module
- Setting the split points
- Using the VALUE encoder to transmit values for a specified parameter
- Using the PC-80 as a MIDI interface
- Using the PC-80 as an audio interface
- System settings for the PC-80
- PC-80 driver settings
- Troubleshooting
- Driver-related problems (Windows)
- Can’t record or play back audio or MIDI/No sound
- Noise or pops are heard when recording/playing on your computer
- Noise or distortion occurs when the PC-80 is not connected to your computer
- The sound is too weak
- Problems with the PC-80 Software Synthesizer
- Won’t start up
- The menu does not appear correctly (can’t select it)
- No sound
- Sound is too loud/too soft
- Clicks, pops, or noise occurs in the sound
- Sounds you play from the keyboard are delayed
- Can’t control sounds or parameters from the PC-80
- Can’t play back song data/Playback is incorrect
- Can’t use the PC-80 software synthesizer from other software
- Uninstalling the PC-80 software synthesizer
- MIDI implementation
- Main specifications
- Index
- Using the PC-80 as a MIDI controller keyboard
95
System settings for the PC-80
Here’s how to assign a specified parameter to the VALUE encoder.
* The assignment of the VALUE encoder is valid only in
Play mode
(p. 60) and in
Controller mode
(p. 67).
fig.util*
1
Simultaneously press the
MIDI CH
button and
PGM CHANGE
button,
and hold them down for a few moments.
The PC-80’s display will indicate “UTL,” and you will be in Utility mode.
fig.sy0
2
Press the
[SYSTEM]
key on the keyboard.
“SY0” appears (blinking) in the display.
3
Use the
VALUE
encoder or the
[5]
key of the keyboard to choose “
SY5
.”
fig.enter
4
Press the
ENTER
button.
* If you press any other button without pressing the ENTER button, the setting will be
cancelled.
5
Use the
VALUE
encoder or the keyboard to specify the parameter.
VALUE ENCODER
Specified parameter
This setting lets you transmit a specified parameter by turning the PC-80’s VALUE encoder.
To transmit the parameter value
When you operate the VALUE encoder in What is Controller mode? (p. 67), the
corresponding value for the parameter you specified will be transmitted.
“Using the VALUE encoder to transmit values for a specified parameter” (p. 78)
PC-80_e.book 95 ページ 2005年11月10日 木曜日 午前11時34分