User Manual

EFCO CORPORATION 6/8/2012 PART NO. YW44 Page 11 of 34
5XPT SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
2. Fasten down the sill starter with job specified anchors. (See Section I. D.) There is a groove
in the sill starter to locate the drill bit. Drill through the sill starter, at the groove, and continue
to drill through the support leg underneath the main web of the sill starter. 3S91 sill starter is
shown; 3S90 sill starter is similar. All blocking and shims will be high strength plastic or non-
corrosive materials. Not by EFCO. (See Fig. F)
3. Seal all exposed anchor heads. Seal between end dam and structure. Seal sill starter to end
dam joint as shown. 3S91 sill starter is shown; 3S90 is similar. (See Fig. G)
The sill starter is now ready to install the Sliding Glass Door frame.
(See the assembly instructions (SECTION III) for assembly of the Sliding Glass Door frame)
Fig. F
Groove location in this area
where anchor head is shown.
Sealant on anchor heads
Seal across face of
end dam to sill starter.
Fig. G
Seal between end dam
and structure.