User Manual

EFCO CORPORATION 6/8/2012 PART NO. YW44 Page 2 of 34
5XPT SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
TABLE OF CONTENTS
Page
I. Sliding Glass Door General Overview
A. General Notes 3
B. Construction Notes 4
C. Building Codes 5
D. Perimeter Anchorage Considerations 6
E. General Sliding Panel Inspection 7
II. General Perimeter Preparation for the Door Frame
A. Opening Condition Verification 8
III. Perimeter Accessory Fabrication for Assembled Doors
A. Subhead Installation 9
B. Sill Starter Installation 11
IV. General Installation Without Subhead
A. Installation Without Subhead 13
(This section will not be required if the job is being supplied with a subhead)
V. Door Frame and Perimeter Sealant Instructions 14
VI. S-5XPT Door Assembly Instructions 19
Minimizing Condensation
Note: Please reference EFCO's "Understanding Condensation" brochure which can be obtained through your EFCO
representative.
Condensation will form on any surface when unfavorable conditions (interior temperature and relative humidity and
exterior temperature) are present. When the formation of excessive condensation is a concern, it is highly recommended that a
design professional is utilized to perform an analysis of the shop drawings to recommend the best possible installation methods.
Please contact your EFCO representative for information on EFCO's Thermal Analysis Services.
Many current installation practices lead to an increase in the possibility of the formation of condensation. Though not all
inclusive, the list of examples below illustrates conditions under which condensation is likely to occur:
1. Bridging system thermal break with non-thermally broken metal flashing or lintels that are exposed to the
exterior
2. System exposure to cold air cavities
3. Interior relative humidity levels not maintained at recommended levels, see EFCO’s “Understanding
Condensation” brochure
4. Inadequate separation between system and surrounding condition at perimeter
5. Product combinations during the shop drawing stage that result in bridging thermal breaks
of one or all products involved