User Manual

EFCO CORPORATION 2/11/2013 PART NO. YW44 Page 29 of 34
5XPT SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
This page will be required if assembling an OXO door.
Otherwise, disregard and proceed to Step 14.
13. When assembling an OXO sliding glass door, locate 14E8 meeting rail. Proceed to engage
with the fixed panel meeting rail. (See Fig. 12) This should only be done after all panels
and thresholds have been sealed in place.
Note: 14E8 meeting rail will have a factory fabricated notch, as shown. (See Fig. 12) This
notch will be located at the head end of the meeting rail.
Once 14E8 is engaged, match drill through factory fabricated holes in the fixed panel
meeting rail with a .156 (5/32”) drill bit. Fasten with STT7 (#10-12 x 1” PH-SMS 18-8 A-pt.)
screws. (See Fig. 12) These fasteners are located approximately 6” from each end, at 12”
o.c.
14E8 OXO
Meeting Rail
STT7 Screws
INTERIOR
EXTERIOR
Fig. 12
Notch at head end
FIXED PANEL
MEETING RAIL