Use and Care Manual
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100 21
The throwing distance of the snow
blower is adjusted by moving the chute
deector up or down (Fig. 19). Release
the bail switch before adjusting the chute
deector.
1. To increase the distance that the
snow is thrown, squeeze the trigger
on the chute-deector handle,
and then raise the chute deector.
Release the trigger on the chute-
deector handle to lock the chute deector in place (Fig.19).
2. To decrease the distance that the snow is thrown, simply lower the deector with
the chute-deector handle.
WARNING:
Do not force the chute so far forward that a gap appears between
the deector and the chute itself. Snow or other debris could be thrown through the
gap and back at the operator, resulting in serious personal injury.
WARNING:
Do not adjust the chute deector while the bail switch is engaged.
Always release the bail switch before adjusting the chute deector.
CLEARING A CLOGGING CHUTE
WARNING:
Hands coming in contact with the rotating auger inside the chute is
the most common cause of injury associated with snow blowers. Never use your hand
to clean out the chute.
To Clear the Chute:
1. Shut the motor and auger off!
2. Remove the battery pack(s) from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use a clean-out tool, such as a wood rod or other clearing tools that are
commercially available; do not use your hand.
19
Trigger
Chute
Deector