Use and Care Manual
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100 25
WARNING:
Make sure that the area to be cleared is free of stones, sticks, wires,
gravel, and other objects that could be accidentally thrown by the snow blower in any
direction and cause serious personal injury to the operator and others.
◾
If the unit comes in contact with any type of obstruction or debris during use, stop
the snow blower, remove the battery pack(s), remove the obstruction, and inspect
the unit carefully for damage before proceeding.
WARNING:
Never reach into the discharge chute or place any body part in front of
the snow blower when the unit is operating or when the battery pack(s) are installed. Always
ensure all moving parts have stopped and the battery pack(s) have been removed before
clearing any obstructions. Failure to follow these instructions can result in serious personal
injury.
◾
Take notice of the direction of the wind before beginning. When possible,
discharge snow in the same direction as the wind to prevent snow from being
thrown back into your face.
◾
Some parts of the snow blower can freeze under extreme weather conditions.
Do not attempt to operate the unit with frozen parts.
◾
When nished, allow the motor to run for an additional few minutes to prevent
moving parts from freezing, then turn the chute rotation handle back and forth
several times to free it from any ice buildup. Make sure to clean off any snow and
ice from the base of the chute.
◾
In snowy and cold conditions, some controls and moving parts may freeze. Do not
use excessive force when trying to operate frozen controls. If you have difculty
operating any control or part, start the machine as “STARTING/STOPING THE
SNOW BLOWER” section shown and let it run for a few minutes.