Use and Care Manual

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT210028

REPLACING THE RUBBER PADDLE

WARNING:

Make sure to turn

off the bail switch and remove the

battery pack(s) before performing any

maintenance task on your snow blower.

NOTICE: When replacing worn rubber

paddles, pay close attention to the order

in which you remove them. Assemble the

new rubber paddles in the reverse order

of the disassembly.

1. Use two 10mm wrenches (not

included) to remove the 8 sets of

nuts and bolts xed on the middle

steel plates and the 4 sets of nuts,

washers and bolts on each side (total

of 8 sets), that are used to secure the

rubber paddles (Fig. 26 & 27).

2. Remove the paddles.

3. Install the new rubber paddles in the

reverse order of the disassembly.

Secure them by tightening the 4

sets of nuts, washers and bolts on

each side (total of 8 sets) and the 8

sets of nuts and bolts in the middle.

REPLACING THE DRIVE BELT

If the drive belt becomes worn, oil-soaked, excessively cracked, frayed, or otherwise

damaged, replace the belt.

WARNING:

Make sure to turn off the bail switch and remove the battery pack(s)

before performing any maintenance task on your snow blower.

1. Use a T20 Torx screwdriver (not included) to remove the drive belt cover by

removing the 8 Torx screws as shown in Fig. 28.

4 sets of bolts, washers and nuts on

each side (total of 8 sets)

8 sets of bolts

and nuts

Steel Plates

Torx screw

Drive Belt

Cover