Use and Care Manual

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100 31
TROUBLESHOOTING
WARNING:
Always remove the battery pack(s) when servicing or transporting
the snow blower. Always protect your hands by wearing gloves when performing any
maintenance on the snow blower auger or scraper.
PROBLEM CAUSE SOLUTION
Side rails are not in
position.
◾
Knobs on the side rails
and/or handle-clamp
lever are not secured.
◾
Make sure that knobs on the side
rails are fully tightened and the
handle-clamp levers are fully
closed.
Snow blower is not starting.
◾
Battery charge is low.
◾
Safety button is not
depressed.
◾
Charge the battery.
◾
Press the safety button and then
squeeze the bail switch.
The motor is on but the
auger does not turn.
◾
The drive belt is worn
or broken.
◾
Replace the drive belt following
the section “REPLACING THE
DRIVE BELT” in this manual.
After passing, the snow
blower leaves a layer of
snow on the ground.
◾
The scraper bar is
worn.
◾
Replace the scraper following
the section “REPLACING THE
SCRAPER BAR” in this manual.
ACCESSORIES
WARNING:
The following parts are subjected to be worn out from normal use.
Use only identical replacement parts listed below. Use of parts that do not meet the
original equipment specications may lead to improper performance and compromised
safety.
PART NAME MODEL NUMBER
Scraper Bar ASS2100
Rubber Paddle ARP2100
Drive Belt AVB2306