Use and Care Guide

56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER—ST1520 & ST1520S 23

3. Insert the line into the eyelet (Fig.15)

and push the line until the end of

the line comes out of the opposite

eyelet.

NOTICE: It is not necessary to align the

eyelets in order to insert the cutting line.

4. Pull the line from the other side until

equal lengths of the line appear on

both sides of the trimmer head

(Fig. 16).

5. Install the battery pack onto the

string trimmer.

6. Press and hold the line-loading

button to start the line-winding

motor. The line will be wound into

the trimmer head continuously

(Fig. 17).

7. Watch the remaining line length

carefully. Prepare to release the

button as soon as approximately 7

inches (17.8cm) of line are left on

each side. Briey press the line-

loading button to adjust the length

until 5.5 inches (14cm) of the line is

showing on each side.

8. Push down on the trimmer head

while pulling on the lines to

manually advance the line in order

to check for proper assembly of the cutting line.

NOTICE: In case the line is pulled into the trimmer head by accident, open the head

and pull the cutting line out from the spool. Follow the section “RELOAD THE CUTTING

LINE” in this manual to reload the line.

Eyelet

Cutting Line

Isometric Cutting Line

5.5" (14cm)