Trimmer Operator's Manual

56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC22

ADJUSTING CUTTING LINE

LENGTH

The trimmer head allows the operator to

release more cutting line without stopping

the motor. As line becomes frayed or worn,

additional line can be released by lightly

tapping the trimmer head on the ground

while operating the trimmer (Fig. 11).

WARNING:

Do not remove or alter

the line cutting blade assembly. Excessive line length will cause the motor to overheat

and may result in serious personal injury.

For best results, tap the trimmer head on bare ground or hard soil. If line release is

attempted in tall grass, the motor may overheat. Always keep the trimming line fully

extended. Line release becomes more difcult as the cutting line becomes shorter.

LINE REPLACEMENT

NOTICE: Always use the recommended nylon cutting line with diameter no more than

0.095 in. (2.4 mm). Using line other than that specied may cause the string trimmer to

overheat or become damaged.

WARNING:

Never use metal-reinforced line, wire, or rope, etc. These can break

off and become dangerous projectiles.

1. Remove the battery pack.

2. Remove the remaining cutting line,

if necessary. Simply pull it out by

hand.

3. Cut one piece of cutting line 16 ft.

(5m) long. Insert the line into the

eyelet. Push the line until the end

of the line comes out of the other

side of the trimmer head. Pull the

line from the other side until equal

amounts of line appear on both sides (Fig. 12).

Arrow Direction

Eyelet