Trimmer Operator's Manual

56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC 23
4. Press and rotate lower cover
assembly in the direction indicated
by the arrow to wind the cutting
line onto the spool that until
approximately 5.5 in. (14cm) of line
is showing on each side (Fig. 13).
5. Push the lower cover assembly
down while pulling on the lines to
manually advance the line and to
check for proper assembly of the
trimmer head.
When the cutting line breaks from the line
outlet or the cutting line is not released
when the trimmer head is tapped, follow
the steps below:
1. Remove the battery pack.
2. Hold the trimmer head as shown in
Fig. 14 and use one thumb to press
one release tab on either side while
gently pulling on the lower cover
assembly with the other hand to
release the tab.
3. Repeat on the other side to release
the other release tab from the
trimmer head.
4. Remove the lower cover assembly
with the spring from the trimmer
head (Fig. 15 & 16).
5. Remove the cutting line from the
spool (Fig. 16).
14
Release Tab
15
Spring
Lower Cover Assembly
16
13
5.5” (14 cm)