Trimmer Operator's Manual

56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC 29

TRANSMISSION GEARS LUBRICATION

The transmission gears in the gear case need to be lubricated periodically with gear

grease. Check the gear case grease level approximately every 50 hours of operation by

removing the sealing screw on the side of the case.

If no grease can be seen along the sides of the gear, follow the steps below to ll with

gear case to 3/4 capacity.

Do not completely ll the transmission gear case.

1. Remove the battery.

2. Hold the string trimmer on its side

so that the sealing screw is facing

upwards (Fig. 28).

3. Use the multi-function wrench

provided to loosen and remove the

sealing screw.

4. Use a grease gun (not included) to

inject some grease into the screw

hole. Do not exceed a level of 3/4 full.

5. Tighten the sealing screw after injection.

CLEAN THE UNIT

◾

Remove the battery.

◾

Clear any grass that may have wrapped itself around the drive shaft or trimmer

head.

◾

Use a small brush or a small vacuum cleaner to clean the air vents on the rear

housing.

◾

Keep the air vents free of obstructions.

◾

Clean the unit using a damp cloth with a mild detergent.

◾

Do not use any strong detergents on the plastic housing or the handle. They can

be damaged by certain aromatic oils, such as pine and lemon, and by solvents

such as kerosene. Moisture can also cause a shock hazard. Wipe off any moisture

with a soft dry cloth.

Gear Case

Sealing Screw