Trimmer Operator's Manual

56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC32
PROBLEM CAUSE SOLUTION
Trimmer head will
not advance line.
◾
The motor shaft or trimmer
head is bound with grass.
◾
Stop the trimmer, remove the
battery, and clean the motor shaft
and trimmer head.
◾
There is not enough line
in the trimmer head or the
line breaks from the eyelet.
◾
Remove the battery and replace
the cutting line follow “LINE
REPLACEMENT” section in this
manual.
◾
The line is tangled in the
trimmer head.
◾
Remove the battery; remove the line
from the trimmer head and rewind
following “LINE REPLACEMENT”
section in this manual.
◾
The line is too short.
◾
Remove the battery and pull the
lines manually while alternately
pressing down and releasing the
trimmer head.
Grass wraps around
trimmer head and
motor housing.
◾
Cutting tall grass at ground
level.
◾
Cut tall grass from the top down,
removing no more than 8 inches in
each pass to prevent wrapping.
The blade is not
cutting the line.
◾
The line-cutting blade on
the edge of the guard has
become dull.
◾
Sharpen the line-cutting blade with a
le or replace it with a new blade.
Cracks on the
trimmer head or
the lower cover
assembly comes
loose from the
upper cover.
◾
The trimmer head is worn
out.
◾
Replace the trimmer head
immediately following “TRIMMER
HEAD REPLACEMENT" section in
this manual.