User Manual

CHARGING BATTERIES

Prior to use this system the internal 12V battery need to be charged for 12 hours. If the Power-switch is in OFF

position and the system is connected to mains, the battery will be (re)charged and the Charge-Led lights!!

Note: Pull the plug out of the mains outlet if the battery is fully charged!!

Before the device the first time is actuated, please charge the battery at least 12 hours and max. 72 hours! Battery

should be regularly charged. For optimal battery life the battery should be charged at least 1x per month. Please

note that if you do not load within 6 weeks, the battery becomes defective !!

TROUBLESHOOTING

One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly for

the suspected problem speaker. If the “normally correct speaker” is experiencing the same difficulties or problems

as the suspected problem speaker, use the information below to isolate the problem.

Problem

Possible cause

Action

No output

Cables

Reseat all connectors

Substitute known good cables

Check solder joins

Inspect cable for damage

Inspect wire or connector for stray strand that may short

Intermittent

Poor connections

While it is possible for a faulty speaker to exhibit intermittent output,

it’s more likely that an output cable/connector is the problem. Check

the soldering on your connectors.

Constant noise,

buzzing and/or

humming

Faulty electronic

Any constant noise originates in the amplifier, mixer, signal

processing, source device in the signal devices, or line-level wiring.

Check and correct system grounding as required. Chain check for

noisy sources or electronic components. Check wiring for shielding.

Poor low-

frequency output

Improper polarity

When two speakers in close proximity to each other are connected

out-of-polarity, they can partially cancel each other out, especially at

low frequencies. Check your speaker cables to be sure they are all

identically wired and connected. Check the balanced line signal

cables to be sure they are all correctly wired.