User manual

Clearing House Codes: The house codes memorised can be deleted (i.e. the

RadioLINK Bases can be uncoded) by pressing and holding the House Code

switch on for about 6 seconds. The amber light will come on and then flash slow-

ly to indicate the smoke alarm has been returned to the default factory settings.

(this also clears the Repeater function).

Repeater Function: The RadioLINK Base receives and then re-broadcasts the

varoius RF signals, so effectively boosting the signal range.

Activating the Repeater Function: Press and hold the test button until the alarm

sounds and the amber light comes on, then immediately (while the light is on) press

and hold the House Code switch until the amber light flashes slowly. The amber

light will flash 15 times to indicate that the RadioLINK Base is now a Repeater

Base.

De-activating the Repeater Function: Press and hold the test button until the

alarm sounds and the amber light comes on, then immediately press and hold the

House Code switch until the amber light flashes slowly. The amber light will flash

only 3 times to indicate that the RadioLINK Base is now no longer a Repeater

Base.