User manual

3. INSTALLATION

WARNING: Mains operated products should be

installed by a qualified electrician per the Regulations

for Electrical Installations contained in the IEE Wiring

Regulations — British Standard 7671. Failure to install

this unit correctly may expose the user to shock or fire

hazards. This unit is not waterproof and must not be

exposed to dripping or splashing.

Up to twelve Ei168 RadioLINK Bases can be inter-

connected using the RF radio link.

1. Select a location complying with the advice in the

Smoke/Heat Alarm instruction leaflet.

2. Disconnect the AC mains supply from the circuit

that is going to be used.

3. Carefully align the RadioLINK Base and screw

into place as shown in figure 1.

(It is advisable at this

time to use only one screw (as shown) as it allows the base

to be rotated later if required. If you use only one screw,

ensure the base is secure on the ceiling before proceeding

further with the installation. Remember to complete the

installation by securing with the second screw after the sys-

tem has been checked).

4. Lift off the wiring cover as shown in figure 2.

Figure 1

INSERT SCREWDRIVER TO

LIFT AND REMOVE WIRE COVER

Figure 2