User manual

20 seconds on each unit. The horn will sound and the amber light on the

RadioLINK Base sidewall will come on continuously for about 3.5 seconds. All

other installed units should now sound. Release the test button. The local alarm

will cease and you should then be able to hear the other alarms sounding in the

distance. (If any of the alarms do not sound see section 5).

13. The units will automatically exit the house code mode after 15 minutes. We

recommend that you manually exit the house code mode by re-pressing and

holding the house code switch on until the amber light turns on. This reduces the

risk of accidently house coding your alarms with nearby systems.

Finally attach the label provided to the distribution board to identify the alarm

circuits.

(Note: To clear house codes see section 10 - Technical Specification)

4. ACTIVATING THE REPEATER FUNCTION

In normal installations (single storey and two-storey houses), the signal range

should be sufficient to activate the alarms. However some Ei168 RadioLINK

Bases may not receive the radio link signals and then it will be necessary to set up

a unit as a REPEATER Base. The function of the Repeater Base is to receive and

re-broadcast the signals, so effectively boosting the signal range throughout the

installation. For the highest RF signal reliability we recommend that a Repeater

Base is used for systems with 3 or more units.

To setup a Repeater Base:

(i) Choose a RadioLINK Base that is centrally located within the house.