User manual

14
GB
5.3 Fitting the drill bit (Fig. 5-6)
n Always pull the power plug before making
adjustments to the equipment.
n Release the depth stop (2) as described in 5.2
and push it towards the drill handle. This provides
free access to the chuck (1).
n Undo the chuck by turning it anti-clockwise with
the supplied chuck key (9).
n To ensure that it is perfectly positioned the drill bit
or tool should be inserted as far as possible into
the chuck. After inserting the drill bit or tool,
tighten the chuck (1) by turning the chuck key (9)
clockwise until the drill bit or tool is secure. Check
that the drill bit is secure in the chuck (1).
n Check at regular intervals that the drill bit or tool is
secure (pull the mains plug).
6. Operation
6.1 ON/OFF switch (Fig. 7/Item 5)
n First fit a suitable drill bit into the tool (see 5.3).
n Connect the mains plug to a suitable socket.
n Position the drill in the position you wish to drill.
To switch on:
Press the ON/OFF switch (5)
Continuous operation:
Secure the ON/OFF switch (5) with the locking
button (4).
To switch off:
Press the ON/OFF switch (5) briefly.
6.2 Adjusting the speed (Fig. 7/Item 5)
n You can infinitely vary the speed whilst using the
tool.
n Select the speed by applying a greater or lesser
pressure to the ON/OFF switch (5).
n Select the correct speed: The most suitable
speed depends on the workpiece, the type of use
and the drill bit used.
n Low pressure on the ON/OFF switch (5): Lower
speed (suitable for: small screws and soft
materials)
n Greater pressure on the ON/OFF switch (5):
Higher speed (suitable for large/long screws and
hard materials)
Tip: Start drilling holes at low speed. Then increase
the speed in stages.
Benefits:
n The drill bit is easier to control when starting the
hole and will not slide away.
n You avoid drilling messy holes (for example in
tiles).
6.3 Preselecting the speed (Fig. 7/Item 6)
n The speed setting ring (6) enables you to define
the maximum speed. The ON/OFF switch (5) can
only be pressed to the defined maximum speed
setting.
n Set the speed using the setting ring (6) on the
ON/OFF switch (5).
n Do not attempt to make this setting whilst the drill
is in use.
6.4 Clockwise/Counter-clockwise switch
(Fig. 7/Item 7)
n Change switch position only when the drill is
at a standstill!
n Switch the direction of the hammer drill using the
clockwise/counter-clockwise switch (7):
Direction Switch position
Clockwise (forwards and drill) Pushed in to the right
Counter-clockwise (reverse) Pushed in to the left
6.5 Drill / hammer drill selector switch
(Fig. 5/Item 3)
Change switch position only when the drill is at a
standstill!
Drill
Drill / hammer drill selector switch (3) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (3) in the hammer
drill position. (Position B)
Use for: Concrete, rock, masonry
6.6 Tips for working with your hammer drill
6.6.1 Drilling concrete and masonry
n Switch the Drill/Hammer drill selector switch (3)
to position B (Hammer drill).
n Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
6.6.2 Drilling steel
n Switch the drill / hammer drill selector switch (3)
to position A (drill).
n Always use HSS drill bits (HSS = high speed
steel) and a low speed setting for drilling steel.
Anleitung_TH_ID_1000_E_SPK1__ 15.07.13 13:28 Seite 14