Use and Care Manual

EN
- 9 -
8. Charger indicator
Indicator status
Explanations and actions
Red LED Green LED
O Flashing Ready for use
The charger is connected to the mains and is ready for use; there is no
battery pack in the charger
On O Charging
The charger is charging the battery pack in quick charge mode.
The charging times are shown directly on the charger.
Important! The actual charging times may vary slightly from the stated
charging times depending on the existing battery charge.
O On The battery is charged and ready for use.
The unit then changes over to gentle charging mode until the battery is
fully charged.
To do this, leave the rechargeable battery on the charger for approx. 15
minutes longer.
Action:
Take the battery pack out of the charger. Disconnect the charger from the
mains supply.
Flashing O Adapted charging
The charger is in gentle charging mode.
For safety reasons the charging is performed less quickly and takes more
time. The reasons can be:
- The rechargeable battery has not been charged for a very long time.
- The battery pack temperature is outside the ideal range (between 50°F
and 113°F (10° C and 45° C)).
Action:
Wait for the charging to be completed; you can still continue to charge the
battery pack.
Flashing Flashing Fault
Charging is no longer possible. The battery pack is defective.
Action:
Never charge a defective battery pack.
Take the battery pack out of the charger.
On On Temperature fault
The battery pack is too hot (e.g. due to direct sunshine) or too cold (below
32°F (0° C)).
Action:
Remove the battery pack and keep it at room temperature (approx. 68°F
(20° C)) for one day.
Anl_PXC_Charger_18V_30min_Kit_SPK7_USA.indb 9Anl_PXC_Charger_18V_30min_Kit_SPK7_USA.indb 9 23.01.2019 16:39:3223.01.2019 16:39:32