Manual
Drawing : - TPC430
Issue : - 3
Date : - 30/11/16
UNPACKING
Remove your EIPL RF3500 from its packing carton and wrapping, visually inspect for any signs of transit damage. If
there are any signs of damage, do not operate your unit. Call your supplier immediately for advice. Do not discard
the packing for it will be useful for transporting your unit in the future.
TRANSPORTATION
Do not drop or abuse your Air Mover during transit for risk of damage to both the motor and housing.
INTRODUCTION
The RF3500 should only be operated in the horizontal position and with the unit standing on a firm and level floor.
A flexible duct can be attached to the either inlet or outlet to transport the air over longer distances. Connection to
the RF3500 is done by using the quick release “belted cuff”, unique to the EIPL RF3500.
OPERATING PROCEDURES
Connect the power cord into a grounded electrical outlet and press the power switch to the ‘I’ position. If you have no
power or hear any loud or abnormal noises then consult your supplier.
Since the RF3500 has a considerably high suction power, always ensure that the inlet grille is kept free of any
obstruction.
To switch the unit off, press the power switch to the ‘O’ position and disconnect from the electrical outlet.
ELECTRICAL CONNECTION
This appliance complies with the suppression requirements of the EEC direction 82/199/EEC as embodied in
BS800:1988.
IMPORTANT:- The wires in this mains lead are coloured in accordance with the following code:-
Green / Yellow Earth
Blue Neutral
Brown Live
Only 13amp fuses that are STA approved to BS1362 should be used. Fuse covers must be refitted after replacement of the fuse.
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your own plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the
letter E or by the Earth Symbol or coloured Green and Yellow. The wire which is coloured Blue must be connected to
the terminal in the plug which is marked with the letter N or coloured Black. The wire which is coloured Brown must
be connected to the terminal which is marked with the letter L or coloured Red.
You must dispose of the non rewireable plug once it has been removed from the flexible cord. It is dangerous to
attempt to insert the plug into any electrical socket elsewhere in the house. If the flexible cord becomes damaged it
must be replaced by an identical cord.
SERVICE
This machine should be serviced by qualified EIPL personnel or other persons having technical competence and
following the instructions in the manual.
TECHNICAL SPECIFICATIONS
RF3500
230V/50Hz/1 PH Power (W)
600
Height
475mm Max running current
3A
Width
411mm Airflow (M3/Hr)
3600
Depth
395mm
Weight
10.5Kg