Technical information

Turning on the Appliance

Starting a wash cycle...

Draw out the lower and upper basket, load the dishes and

push them back. It is commended that loading the lower

basket first, than the upper one (see the section entitled

“Loading the Dishwasher”).

Pour in the detergent (see the section entitled “Salt,

Detergent and Rinse Aid”).

Insert the plug into the socket. The power supply is 220-240

VAC 50 HZ, the specification of the socket is 12 A 250 VAC.

Make sure that the water supply is turned on to full pressure.

With a little force to ensure the door is properly closed.

NOTE: A click could be heard when the door is closed perfectly.

Close the door,press the ON/OFFbutton,and the ON/OFF light will

turn on.

Press the "prog. "Button to select a desired "Wash cycle".(see

the section entitled."Wash Cycle Table".) P the

program

When the washing is over, you can shut off the switch by

pressing ON/OFF button.

ress start/reset button

to starting the .

Premise: A cycle that is underway can only be modified if it

has only been running for a short time. Otherwise, the detergent

may have already been released, and the appliance may have

already drained the wash water. If this is the case, the detergent

dispenser must be refilled (see the section entitled " Loading the

Detergent " ).

Press the start/reset button, then press current prog. button

more than three seconds to cancel the program , you can change the

program to the desired cycle setting (see the section entitled

"Startingawashcycle...").

NOTE:

If you open the door when washing, the machine

will pause. When you close the door , the machine will keep on working after 10 seconds.

If you open the door , the machine will pause.

And the machine will then continue to run only if you press after closing the door.

OFF

Pr og .

Start R eset