User Manual

5
PARTS LIST
ASSEMBLY
Tools Needed:
Pencil Hammer Spirit Level Screw Driver Drill
A wall mounting bracket is provide with the heater which has been specifically designed to allow
this product to be fitted to a ceiling or wall.
Before any drilling or installation commences, ensure that the wall or ceiling you are using for
installation is free from wires and pipes. The heater must be installed no less than 19.7 inches from
side walls and no less than 2.4m off the floor. The appliance must be installed on the solid surfaces
like concrete, wood or metal etc.
Important: Ensure that the supply cables are well mounted and that it does not come into contact
with reflector of the heater or that does not come into contact with the heated area. The supply
cable can be fixed to the metal mounting bracket behind heater with plastic zip ties (not provided).
1. This heater should be installed by a competent person, i.e. a qualified electrician.
2. For ceiling mounting, the lowest part of the heater must be located at or above a minimum
height of 1.8m from ground level, so that the heater cannot be touched when in operation.
3. When installed to the ceiling, there must be a distance of 0.5m between ceiling corners and the
appliance.
4. The distance from the front side of the heater to materials such as wood, carton, cloth, people
and animals must be min 1m.
5. When mounting to a ceiling, do not position the heater at an angle more than 90°and less than
45°.
6. The supply cable must be at the lower end of the heater if the heater is installed at an angle or
vertically.
7. If the heater is to be used outside, a weatherproof outlet is recommended.
8. The heater must be installed on the mounting brackets provided.
9. Fasten the heater securely on the brackets using the nuts and bolts supplied.
10. The brackets can be used to adjust the direction of the heater, adjust the heater angle by
loosening the two bolts on the wall mounting bracket, tighten the bolts again when the desired
angle is reached.
PARTS
PART
NO.
PART NAME
QTY
1
L shape bracket
4
2
Wall plugs
4
3
Screws PA5mm*25mm
4
4
Screws M6mm*12mm
5
M6mm locking nut
2
6
Washer
2
7
M6mm*12mm screw
2