User Manual

8
INSERTING BATTERIES
Insert 2 AAA type batteries into your remote control
1. Flip the backside of your remote control and pull out battery cover. Insert the
batteries in accordance with the instructions and polarity the batteries.
2. Change the batteries in the same way depicted above.
NOTICE:
1. Replace the old batteries with the same type batteries. Otherwise, your heater
may not function well.
2. Pull out the batteries in case of long terms of disuse to prevent leakage which
may impair your remote control.
3. Do not allow water or liquid to get into the remote control.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will
invalidate the warranty and may cause bodily harm.
Issue
Possible Reason
Solution
No power
1. Power cord is unconnected
2. There is no power from socket
3. The power switch on the rear of the unit
is turned off.
1. Connect the power cord
2. Check socket is turned on
3. Ensure the power switch on
the rear of the unit is in the on
position
Odour
emission
from unit
1. New unit. When the unit is used for the
first time the heater may produce and odour
which will dissipate within a week of use
1. No action required
CLEANING AND MAINTENANCE
ATTENTION: Please turn off the unit and unplug from the mains and allow to
fully cool before cleaning or performing any maintenance.
CLEANING THE SURFACE
• Clean the heater with a duster or a soft wet cloth.
• Do not use chemical solvents (such as benzene, alcohol or gasoline) as they
may cause irreversible damage. Make sure no water enters the control panel or
gaps in the casing.
• Do not run the unit until completely dry.
• Place the heater in its original box or cover to protect it from dust when not in
use.