User Manual

OPERATING INSTRUCTIONS

BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE

PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-CLOCKWISE TO THE

PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE ATTEMPTING IGNITION.

BATTERY REPLACMENT

Remove the control dial. Install 1 AA battery. The negative end of battery goes in first, then replace the control dial.

LIGHTING THE PATIO HEATER

• Check all connections prior to each use.

• Turn on the gas supply at source.

• Press and turn the control dial anti-clockwise to the LOW (small flame)

marking. You will hear a click and this will light the burner.

• Keep control dial depressed for up to 30 seconds then release the

control dial.

• If the gas fails to ignite, press and turn the dial clockwise to OFF before repeating the lighting steps.

• Turn the dial further anticlockwise to the LOW position.

• Adjust the heat by turning the dial from the LOW position to the HIGH position as required.

Note: it is possible to light the appliance using a long match by lighting the

burner through the ignition hole in the emitter screen.

RE-LIGHTING

• Turn the Dial to the OFF position.

• Wait 5 minutes, to let gas dissipate, before attempting to re-light burner.

• Repeat the “Lighting” steps.

TO EXTINGUISH

• Hold the dial down and turn clockwise to the OFF position

• Turn off the valve on the gas cylinder or the regulator after use.

• Disconnect the gas bottle and allow this appliance to cool before moving the appliance.

Note: After use, some discoloration of the emitter screen is normal. Turn off the regulator after use and allow

the appliance to cool before moving.