Datasheet

Page 1

SWAJ

Safewash Jigwash

SWAJ removes all types of flux residues (RA, RMA, no-clean and water-soluble) quickly and efficiently, using a

range of different production equipment. It contains a corrosion inhibitor allowing the safe cleaning of all metals

including aluminium, copper and brass and has enhanced rinsability. SWAJ is part of the Electrolube Safewash

range; water-based, non-flammable, biodegradable solvent blends designed to clean to within military

cleanliness standards, (ANSI-J-001B/IPC TM-650).

• Contains a corrosion inhibitor; safe for use on sensitive metals

• Removes all types of flux residues; suitable for many PCB cleaning processes

• Ready to use for ultrasonic applications; no dilution required

• Non-flammable product, 100% ozone friendly; suitable for use in standard cleaning equipment

Approvals RoHS-2 Compliant (2011/65/EU): Yes

Typical Properties Appearance Green Liquid

Boiling Point (°C) 98

Flash Point (°C) None

Freezing Point (°C) -5

Density @ 20°C (g/ml) 1.002

Viscosity @ 20°C (mPa s) 5-10

pH 11.7

Conductivity @ 18°C (mS) 1.6

Description Packaging Order Code Shelf Life

Safewash SWAJ

400ml aerosol with integral brush SWA400H 48 Months

5 Litre SWAJ05L 48 Months

25 Litre SWAJ25L 48 Months

200 Litre SWAJ200L 48 Months

PAGE 1
Page 1 SWAJ Safewash Jigwash SWAJ removes all types of flux residues (RA, RMA, no-clean and water-soluble) quickly and efficiently, using a range of different production equipment. It contains a corrosion inhibitor allowing the safe cleaning of all metals including aluminium, copper and brass and has enhanced rinsability.
PAGE 2
Page 2 Directions for Use SWAJ has been specifically developed for use in 3 or 4 stage batch cleaning systems using ultrasonic or sprayunder-immersion. It is supplied at a concentration suitable for immediate use and further dilution is not recommended. In typical usage times and temperatures, SWAJ has excellent compatibility with most materials used in the electronics industry, and with materials used in cleaning equipment.
PAGE 3
Page 3 For wave solder fluxes, take 150ml of a 10% flux and evaporate to ca. 50ml. (CARE - solvent is usually highly flammable). Dissolve this material in 100ml of Safewash to give a standard 15% solution. Measure conductivity at 20°C and construct a graph. In production, the conductivity of the cleaning solution may now be monitored. When the conductivity indicates flux levels of 10-15%, or a concentration above which Safewash does not clean to an acceptable level, the bulk material should be replaced.