Installation Instructions

STEP 15 DISHWASHER WET TEST

 Turn on power supply (or plug power cord into

outlet, if equipped).

 Turn dial to Normal "Wash" position.

 Close door.

 Check to be sure that water enters the dishwasher.

If water does not enter the dishwasher, check to be

sure that water and power are turned on.

 Check for leaks under the dishwasher. If a leak is

found, turn power supply off, then tighten connec-

tions. Restore power after leak is corrected.

 Check for leaks around the door. A leak around the

door could be caused by door rubbing or hitting

against adjacent cabinetry. Reposition the dish-

washer if necessary. See step 9.

 The dishwasher will drain and turn off about 5 to 7

minutes after the first fill. Check drain lines. If leaks

are found, turn power off at the breaker and correct

plumbing as necessary. Restore power after

corrections are made. See Step 12.

 Open Dishwasher door and make sure most of the

water has drained. If not, check that disposer plug

has been removed and /or air gap is not plugged.

See Step 13. Also check drain line for kinking.

 Run the dishwasher through another fill and drain

cycle. Check for leaks and correct if required.

 At the end of drain, open door and turn dial to OFF

position.

STEP 17 LITERATURE

Be sure to leave complete literature package and

installation instructions with consumer.

STEP 16 REPLACE TOEKICK

• Place 2-piece toekick against the legs of the

dishwasher.

• Place the inner toekick piece (with slots) against

the toekick bracket. The slots should align with

toekick bracket screw holes. Allow the toekick

to touch the floor.

• Place larger toekick over the inner piece and

install 4 toekick screws.

• Use additional 2 screws that are provided for

installations over 33-1/2" high.

• Use both toekick pieces for all installation

heights.